ANAND INDUSTRIES IN PATNA BIHAR

ANANDKUMAR01

Manufacturing of pavers is done on two types of machines in general. The first being more popular, more productive, cost effective, yielding high strength product is through Block Making Machines. The movements are controlled through hydraulics and the compaction is done through eccentric weight vibrators. An aggregate mix of sand, rock, and cement. The mixture is then poured into a mold called "the shoes." The mixture is then hammered into the mold using several thousand pounds of pressure from the eccentric weight vibrators. They are typically then tested to make sure that the water to mixture ration is correct. Following this, the pavers go through a curing process that can last eighteen to twenty days. The curing process and additional processes can vary based on the style of paver.[2] The other choice is of Hydraulic press machines that deny each of the above mentioned advantages still common in few countries because of their low capital demand. There is no vibration to move the material in the mold thus voids may remain

HOUSE NO_50, EAST ASOK NAGAR ROAD NO -14, KANKAR BAGH,PATNA

Patna